Viega MegaPress 316 1.25-Inch FKM 90-Degree Elbow

The Viega MegaPress 316 Elbow turns 1-1/4 inch pipe through 90 degrees, in 316 stainless with FKM sealing elements.

A ninety degree elbow is used where a run has to turn hard, typically at a bulkhead or where pipe drops from an overhead into a locker. The cost is flow. A sharp turn creates more resistance than a gradual one, and long runs use two forty-five degree bends where space allows rather than a single right angle.

Pressing rather than welding means the joint is made in place without heat, which matters in a confined engine space where a torch is impractical and often not permitted. The fitting suits Schedule 5 through Schedule 40 stainless pipe, covering both thin and standard wall thicknesses. Explore more marine pipe and fittings.

• Turns 1-1/4 inch pipe through 90 degrees
• For bulkhead penetrations and hard direction changes
• Costs more flow than two 45 degree bends
• Pressed in place, with no torch in a confined space