Rule Rule-Mate 800 GPH Fully Automated Bilge Pump 12V

The Rule Rule-Mate 800 combines a bilge pump and automatic water sensing in one compact housing for unattended bilge-water removal. The integrated design eliminates the need to install a separate float switch, simplifying wiring and reducing the number of individual components that must fit into a crowded bilge.

Rule-Mate electronic control monitors for water and runs the pump when required, then stops pumping when the bilge has been cleared to the system's designed level. The compact assembly is intended for 12V marine electrical systems and gives a straightforward automatic solution for smaller bilges and secondary pumping locations.

Confirm mounting space, discharge-hose routing, fuse or circuit protection, wire sizing, and service access before installation. Keep the sensing area clear of debris, route wiring securely above standing water where practical, and test automatic operation after installation. Browse additional bilge water pumps when comparing capacities for the boat. Browse more bilge and water pumps.

• Integrated sensing starts and stops the pump without a separate float switch.
• Pump and control electronics share one housing.
• Electronic water detection avoids a conventional external float arm.
• The compact assembly can be serviced more easily when installed in an accessible location.