BEP Marine Gray 6-Switch Waterproof Panel

The BEP Marine waterproof switch panel is a compact control center for boats that need protected accessory switching without a large dashboard footprint. Its enclosed layout is built for wet locations where spray and incidental moisture can reach the panel during normal use. Inline fuse holders are supplied with fuses, so the branch circuits can be protected close to the switching point rather than relying on a separate fuse panel. The gray face keeps the installation neutral enough to blend into a wide range of helm and console layouts.

The panel also incorporates protected power-receptacle provisions used across the waterproof panel family. Its compact body measures approximately 3.75 x 4.25 x 2.9 in, which makes it easier to fit into consoles with limited rear clearance. Switch hardware is designed for substantial DC accessory loads, while the sealed panel construction helps shield the working components from spray. A supplied LBL-WP label set gives the installer a clean way to identify the finished circuits. The switch hardware is rated for 20A DC service. The enclosure is specified to IP56 for the supplier's waterproof-panel design.

• Compact enclosure for crowded helm or console installations
• Protected construction for exposed marine panels
• Includes LBL-WP circuit labels

Plan the panel opening so the fuse holders and wiring remain accessible after installation. Use appropriately sized conductors and branch protection for every connected accessory rather than treating the panel as a substitute for system-level circuit design. For compatible replacement parts and related equipment, browse more Marine Switch Panels.