Fireboy-Xintex Two Zone Detection and Alarm Panel

This Fireboy-Xintex Two Zone Detection & Alarm Panel is a 12/24V DC system that keeps an eye on two separate zones from a single monitor, with each zone able to run up to 14 smoke, heat, or rate-of-rise heat detectors (sold separately). The 2-5/8" display is water resistant, so it holds up in a helm or engine room environment rather than a panel built for dry indoor use only.

Both visual and audible alarms fire the moment a fire or fault is detected, and the electronics are protected against voltage spikes, EMI interference, and reverse polarity, so a wiring mistake during install won't take out the panel. Actual supply voltage runs 9 to 32V DC, with each zone loop held steady at 24V DC regardless of what the input voltage is doing.

The buzzer runs off a 2A relay output, and the fault/alarm output uses a potential-free transistor, meaning it's electrically isolated from the rest of the circuit.

See our other gas & carbon monoxide detectors.

• Sensors per zone up to 8
• Max current per zone 400mA
• Minimum alarm current 15mA
• End-of-line resistor 5.6kΩ
• Transistor output rating 50V max