Trident 5/8-Inch Red 50-Foot Hot Water Feed Hose

This Trident hot-water feed hose increases the inside diameter to 5/8 inch while keeping the easily recognized translucent red cover. Its FDA-grade inner tube is intended for potable-water applications where a larger flow passage is needed. The 50-foot length allows the installer to cut a continuous run between marine plumbing components.

A reinforced PVC wall gives the line flexibility while supporting pressurized service. For the 5/8-inch version, Trident specifies 230 psi working pressure rather than the 250 psi rating of its smaller 1/2-inch hose. The temperature range is -18°F to 149°F, and the minimum bend radius is 1.26 inches. An outside diameter of approximately 0.866 inch should be considered when routing through bulkheads and clamps. Three-ply polyester reinforcement contributes to abrasion resistance without obscuring the red hot-water identification.

Select this hose based on both the heater or fixture connection size and the required operating conditions. The larger tube will not seal correctly on a fitting intended for the smaller 1/2-inch line, even though the two share the same color and construction family. Find other hose diameters and constructions in our marine water and bilge hose range.

• Larger 5/8-inch bore for appropriate hot-water fittings
• Translucent red wall distinguishes the hot-water circuit
• FDA-grade tube intended for potable-water systems
• Three-ply polyester reinforcement supports flexible routing