Trident 3/4-Inch 50-Foot White Corrugated Bilge Hose

This Trident white corrugated bilge hose is made for flexible intake and discharge runs rather than rigid pipe installations. Its 3/4-inch inside diameter suits smaller bilge outlets and similar drainage connections. The polyethylene wall bends readily and resists contact with oily bilge water and seawater.

Regularly spaced cuffs, located approximately every foot, create smooth sections for clamping the corrugated hose. The listed temperature range is -40°F to 200°F, covering a broad variety of bilge conditions. Corrugation makes the hose easier to bend around obstructions, but it must still be supported to prevent sagging. Trident explicitly warns against using this hose for below-waterline through-hull connections.

A 50-foot boxed length gives the installer room to cut replacement sections for the required route. Locate the smooth cuff sections before cutting so there is an appropriate clamping area at each hose end. Keep the discharge route clear of moving gear and avoid tight loops that could trap water. Browse our marine water and bilge hose collection for other corrugated and reinforced hoses.

• Flexible corrugated polyethylene construction
• Smooth clamping cuffs spaced every foot
• Resists oily bilge water and seawater
• Not intended for below-waterline thru-hulls