T-H Marine Stainless Toggle Mounting Hardware Kit

The T-H Marine Toggle Anchor Kit is stainless steel mounting hardware, not a boat anchor. It secures accessories to decks and bulkheads where you can't reach the back side to install a nut and washer. That makes it useful for trolling motors, table pedestals and seat bases on enclosed decks. Toggle anchors grip from behind the panel, so they hold firmly where a screw alone would pull out.

The toggle measures 2 inches long by 0.45 inches wide and fits through a 1/2 inch mounting hole. Once it's through, it sits behind the panel and spreads the load. It accepts standard 1/4-20 fasteners. Stainless steel won't rust or stain the deck.

T-H Marine made the kit for accessories that put high torque on the fastening point. Trolling motor mounts and pedestal seats twist and lever against the deck every time they're used. Use marine sealant around the hole to keep water out of the core. Browse more boat anchors.

• Mounts accessories where the back of the panel is out of reach
• Holds up to high-torque loads from trolling motors and pedestals
• Accepts standard 1/4-20 fasteners
• Installs through a 1/2 inch hole
• Requires a ½” mounting hole