SeaDek 40 x 80 in Camel/Beach Sand Brushed Deck Sheet

Choose this Camel and Beach Sand SeaDek sheet when the deck layout calls for a cut-to-fit solution. The full 40 x 80 in panel can be measured and trimmed for more than one smaller section. A brushed upper surface supplies traction, while the two-tone design determines the final appearance. Matching the pattern direction across adjacent cut pieces helps the finished installation look consistent.

Because this is sheet stock, you can decide how the final pads fit the available deck space. Lay out large pieces first, then use remaining material for appropriately sized smaller sections if the project allows. The 6mm thickness is consistent across the sheet and should be considered around doors, hatches, and trim. Allow for the opening of any nearby hatch or compartment when deciding where the sheet should terminate.

A peel-and-stick adhesive layer is supplied on the back of this sheet. Check the deck surface for contamination and moisture and follow SeaDek’s installation guidance before applying it. Unlike a removable mat, the adhesive-backed sheet stays fitted to the section of deck you cut it for.

Key Features:

• 40 x 80 in full sheet with 6mm thickness
• Two-tone brushed finish for a distinctive deck appearance
• Brushed, non-skid surface for marine applications
• Cut-to-fit sheet for custom layouts
• Factory-applied pressure-sensitive adhesive backing

Browse more boat outfitting accessories.