VETUS V2 CAN Bus Network Terminating Resistor

The VETUS V2 CAN terminating resistor is used at an end point of a compatible marine CAN bus network. A terminating resistor helps maintain the electrical signaling conditions required for reliable data communication. This part is intended for networks that call for the V2 termination component. It is not a substitute for an ordinary inline connector or a general-purpose resistor.

CAN networks require termination at the locations specified by their wiring design. Adding a resistor in the wrong place, or fitting too many, can interfere with communication between connected controls. Consult the VETUS wiring diagram to identify the correct end of the line. The connector should be fitted securely and kept clear of avoidable strain on the cabling.

Its marine-grade construction is intended for onboard network installations. It is most relevant when building, extending, or troubleshooting a VETUS network that uses this termination version. Check compatibility with the installed equipment rather than selecting a terminator by appearance alone. Other installation components can be found in General Boat Outfitting.

• Terminates a compatible marine CAN bus line
• Used where network layout specifies an end termination
• V2 termination component for compatible VETUS CAN systems