Uflex Power A 12V Systems Power Supply Unit

The Uflex Power A Power Supply Unit feeds the Power A electronic control system and is required in every Power A Mark II installation. It powers up to four modules. It accepts input from up to two batteries at 12V or 24V.

A stable power supply is the foundation of any electronic control system, since low or noisy voltage can cause erratic throttle and shift behavior. Because it accepts two batteries, you can wire it to a house and a start battery so the controls stay powered if one runs low. The unit is IP65 rated and measures 8 x 4.3 inches. One supply can feed the throttle, shift, and other Power A modules on a single-engine boat, which keeps the wiring layout simple. A good power supply is the foundation of a reliable electronic control installation.

Plan the battery connections and module count before installing, and keep wiring runs short and protected. Mount the unit in a dry location, label the battery leads, and check the connections and terminals at each service. The shift and throttle modules it powers are in our engine controls & ignition.

• Required for Power A Mark II systems
• Powers up to four modules
• Up to two batteries, 12V or 24V
• IP65 rated