Tigress 9-Inch 0-Degree Screwless Steel Rod Holder

The Tigress Rod Holder is a 9 inch 0-degree screwless flush mount in 316 stainless, needing a 2-1/8 inch cutout and an installation wrench.

Zero degrees holds a rod vertical, which is a storage and transit position rather than a fishing one. Rods stand upright out of the way, clear of the cockpit and clear of each other. It is also the correct angle for a downrigger rod, where the line runs down rather than back and a raked holder would put a bend in the rod.

A 9 inch tube supports the rod butt over its full depth, which stops the rod pivoting and working against the collar under load. Screwless mounting leaves no fastener heads on the gunwale to snag line or let water into a cored deck. Explore more rod holders.

• 0 degrees, holding rods vertical for storage and transit
• The correct angle for downrigger rods
• 9 inch tube stops the rod pivoting under load
• Screwless, needing a 2-1/8 inch cutout