T-H Marine 10-Inch Hole Shot Plate for Z-Lock Jack Plate

The T-H Marine 10-inch hole-shot plate mounts beneath a compatible Z-Lock jack plate to reduce water drag during acceleration. By closing the open area under the jack plate, it can help the boat transition onto plane more efficiently while also functioning as a center trim surface during lower-speed operation.

The bolt-on design is sized for the listed 10-inch Z-Lock setback, allowing the performance accessory to be added without replacing the primary jack plate. The source information reports improved hole-shot performance by reducing takeoff drag and notes that the plate can help the boat remain on plane at lower speeds.

Confirm the exact Z-Lock jack-plate model, 10-inch setback, engine application, mounting-hole alignment, and lower-unit clearance before installation. Check full steering and jack-plate travel to ensure the plate cannot contact the engine or other hardware. Tighten mounting fasteners securely and inspect them periodically after use.

• Closing the area beneath the jack plate can improve water flow as the boat comes onto plane.
• The plate can act as a center trim surface in compatible setups.
• Bolt-on construction integrates with the specified Z-Lock system.
• Application-specific sizing supports proper fit and clearance.

Find more in our jack plates & accessories.