Scanstrut ROKK 10W Surface Mount Wireless Charger

The Scanstrut ROKK 10W Surface Mount Wireless Charger is a fully encapsulated IPX6 Qi-certified unit fixed with four screws and a cable pass-through.

Full encapsulation is what gives this its IPX6 rating, with the electronics sealed rather than housed in a case. There is no seam, gasket or joint to fail, which is the usual way a sealed marine fitting stops being sealed after a few seasons.

The larger active area makes phone alignment less critical than earlier versions, and the upgraded 10W output charges faster than lower-wattage predecessors. It is independently Qi certified rather than simply claiming compatibility.

Installation uses four screws, a drilling template and a waterproof cable pass-through. The template matters on a curved or textured console where marking four holes accurately by hand is harder than it sounds. It works with many slim non-metallic cases within the supported thickness. Explore more battery charging accessories.

• Fully encapsulated, with no seam or gasket to fail
• That is how sealed fittings usually stop being sealed
• Larger active area eases phone alignment
• Drilling template supplied for accurate mounting