Megaware KeelGuard 7-Foot Keel Protector - Black

The Megaware KeelGuard 7-foot keel protector is a do-it-yourself abrasion barrier built to protect a fiberglass boat’s keel from damage caused by sand, rocks, concrete ramps, oyster beds, and repeated beaching. Protecting the gelcoat helps reduce the chance that abrasion will expose the underlying fiberglass laminate to water and more costly structural repair.

Its patented construction combines a tough, pliable blend of polymers and urethanes with 3M acrylic pressure-sensitive adhesive. Contoured edges bond and seal against the hull, while angled grooves create hydrodynamic channels and air pockets that help the protector move cleanly through the water without adding a bulky flat strip along the keel.

This version is 7 feet long and finished in black, with UV stabilization intended to preserve its appearance during outdoor exposure. The source lists this length for boats up to approximately 20 feet and identifies the protector as 5 inches wide and made in the USA. Careful surface preparation, alignment, and adhesive application are essential for a durable installation.

• The tough protective strip helps prevent gelcoat damage from ramps, rocks, sand, oyster beds, and beaching.
• 3M acrylic pressure-sensitive adhesive secures and seals the contoured edges when the hull is properly prepared.
• Angled grooves form hydrodynamic channels and air pockets along the protector’s surface.
• The do-it-yourself design gives preventive keel protection before abrasion becomes expensive hull damage.
• Pliable polymers and urethanes combine impact tolerance, abrasion resistance, and long-term flexibility.

Have a look at the rest of our keel protectors.