Hella Warm White/Red Surface Strip Light with Switch

This Hella Surface Strip Light with Switch, in Warm White/Red at 12V, has a clever waterproof switch built into the fixture itself. It's sealed shut, resists UV, and won't corrode, its ultra-low profile makes installation easy for either interior or exterior use.

Real light output at under 3W power draw makes it a strong replacement for bulky fluorescent fixtures, producing 250 lumens in white with a CRI rating of 85, high enough to render colors accurately rather than washing everything out under a flat, generic white.

The sealed switch system keeps moisture and contaminants away from the electronics, and the low-profile design allows a effortless surface mount install almost anywhere on board. Snap-on end caps cover the fastenings at each end for a clean, modern look.

Built specifically for the marine environment, these lamps are saltwater durable and thoroughly tested against vibration, impact, and shock loads. The housing is precision-manufactured UV-resistant acrylic, completely sealed for wet or dry use, interior or exterior.

Well suited as a chart lamp, above a bench top, a bulkhead light, or around a bait board, among plenty of other uses. Backed by a 5-year warranty.

Look through the rest of our interior & courtesy lights.

• Runs at 5000K for white, 2700K for warm white
• Power draw under 3.0W (0.25A at 12V, 0.16A at 24V)
• Works with the Hella Marine 5XA 998 572-001 dimmer
• Cable pre-wired, 500mm twin-core