Commodore 3.0 GPM Marine Dry Bilge System

The Commodore 3.0 GPM Marine Dry Bilge System is built to remove the small amount of standing water that conventional bilge pumps often leave behind. Its self-priming suction arrangement can be routed into tight, low areas of the bilge, helping keep compartments drier between normal bilge-pump cycles.

A programmable timer allows automatic operation at intervals selected by the user, while an automatic-off-manual control also permits direct activation when needed. The narrow suction hose can reach confined areas, and the pump can be mounted remotely from the pickup point for more flexible installation.

This system supplements rather than replaces the vessel's primary bilge pumps. Confirm electrical protection, suction routing, discharge destination, mounting location, timer settings, and service access before installation. Test each pickup point and inspect the system routinely so debris, kinks, or loose fittings do not interfere with residual-water removal. Compare with our other bilge and water pumps.

• The small suction pickup reaches low areas of the bilge.
• A programmable timer supports automatic operation at user-selected intervals.
• Self-priming suction gives flexibility in component placement.
• The control includes a manual operating position in addition to automatic use.