Bluewater 2 m Non-Fused NMEA 2000 Power Cable

The Bluewater non-fused power cable provides a direct way to feed an NMEA 2000 backbone when circuit protection is already installed elsewhere in the vessel wiring. One end uses a molded network connector, while the opposite end terminates in stripped conductors for connection to the boat electrical system. That arrangement gives installers more control over where the fuse or breaker is placed instead of forcing protection into the cable assembly itself. It is useful for OEM wiring, custom refits, and replacement work where the existing protection scheme will be retained.

The cable is built for marine-network service and is intended to deliver stable power to compatible backbone components and connected electronics. Its molded connector supports a secure network-side connection, while the open lead end can be terminated to suit the vessel distribution system. The fuse-free design should only be used where appropriate overcurrent protection is provided upstream. This makes planning the power source and circuit protection an important part of the installation rather than an afterthought.

• Molded network connector on one end
• Stripped power leads on the opposite end
• Designed for systems with separate upstream circuit protection
• Useful for OEM, replacement, and custom network installations

Connect the cable to a properly protected source and keep the network power feed positioned according to the requirements of the installed backbone. Route the conductors away from sharp edges and high-current wiring that could complicate service or troubleshooting. For other power leads, tees, drop cables, and marine network components, browse Marine Networking.