BEP Marine SPST Wire-Lead Push-Pull Switch

The BEP Marine push-pull switch is a simple maintained control for a single onboard circuit. Pulling the knob energizes the circuit and pushing it back returns the switch to off, making the operation easy to understand even without looking at the panel. Heavy-duty noncorrosive construction is intended for marine and vehicle environments where moisture and dirt are common. The plasticized body helps keep contamination away from the internal mechanism.

Brass is used for the case, stem, terminals, and mounting hardware, while moisture-repellent insulators support dependable operation in damp locations. Two preattached wire leads simplify connection behind the panel and reduce the number of exposed terminals in the finished installation. The screw-on knob can be removed during installation or replaced if it becomes damaged. The switch also cross-references to Cole Hersee M-606 for replacement applications. The switch is specified for 6-36V DC service and carries a 10A rating at 12V DC. Two 8 in 16 AWG wire leads are supplied, and the mounting body fits panels up to 5/8 in thick.

• Maintained push-pull control for one circuit
• Brass case, stem, terminals, and mounting hardware
• Moisture-resistant plasticized body
• Includes prewired leads for easier installation

Route the leads so they are supported behind the panel and cannot rub on sharp edges or moving hardware. Use upstream overcurrent protection sized for both the connected equipment and the conductor. For compatible replacement parts and related equipment, browse more Marine Electrical Switches.