Bennett EIC 30-Foot Trim Tab Wire Harness

The Bennett EIC 30-foot wire harness is a replacement or installation cable for compatible Bennett Trim Tab Electronic Indicator Control systems. It provides the dedicated wiring path needed to connect system components across the boat while preserving the matched connections used by the EIC architecture.

A full 30-foot length gives installers flexibility on larger boats or layouts where the helm and transom equipment are separated by long interior routing paths. Using the correct purpose-built harness helps avoid improvised splices that can complicate troubleshooting and create additional connection points in a marine electrical system.

This harness does not add control or indication functions by itself; it is the interconnect cable for a compatible EIC installation. Before routing it through the boat, confirm the Bennett system generation, connector compatibility, required path, and whether the full cable length can be supported and protected properly. Find more in our Bennett. Explore more boating.

• The long harness supports boats where the helm and transom require an extended cable route.
• A purpose-built cable reduces extra connection points that can complicate marine electrical troubleshooting.
• Using the correct harness preserves the intended connector arrangement within the EIC system.
• The harness can restore the interconnect path while retaining compatible EIC hardware.